![]() So if you don't know that, and you have offsets enabled in raisetouch, and you send gcode with offsets= double offsets. ![]() The NEW way is the Raisetouch application (the LCD control panel and print file gcode streaming application) has a setting to either use the old way, or use the new way where the offsets are stored in this as settings in raisetouch and since that's on the printer, it applies the offsets before sending the gcode line by line to the motion board. Imagine a group or business with multiple printers and keeping track of customized offsets for each printer. The problem was, fine tuning adjustments had to be made at the slicer, the entire gcode resliced, and then that gcode was ONLY valid for that printer. This will create supports that start somewhere on. I say this, because the OLD way was your gcode for left and right extruder had offsets. Under Advanced Support make sure to check Allow Top Connections for models requiring tall support structures. You need to know what version of raisetouch you are running and what defaults you have set. What are some tips and tricks for aligning and snapping 3D models to curved or irregular surfaces Use grids and reference planes Use snapping modes and. ![]() Just a reminder, this got extra complicated when they changed how dual extrusion offsets work in the raisetouch application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |